Try These Cisco 300-370 Exam Questions – Updated 2018

Free demo of Cisco Certified Network Professional Wireless 300-370 certification exam is available before the real 300-370 exam purchase once you are sure about the 300-370 exam purchase then make the payment and get the Cisco Troubleshooting Cisco Wireless Enterprise Networks 300-370 exam dumps practice software instantly. PDF Questions and Answers booklet with the Cisco 300-370 exam practice software is also available with an attractive offer of 30% discount. The booklet and practice test software together facilitates you for learning and practice both in the best manner. The most updated Cisco Troubleshooting Cisco Wireless Enterprise Networks 300-370 exam questions of Cisco 300-370 exam are provided in the PDF booklet.

300-370 exam questions, 300-370 PDF dumps; 300-370 exam dumps:: https://www.dumpsschool.com/300-370-exam-dumps.html (60 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 300-370 Dumps Exam Questions and Answers:

Version 8.0
Question: 21

A WLC receives a coverage hole detection alert from an AP. What two conditions must occur for the controller to dynamically mitigate the situation? (Choose two.)

A. The AP serving the troubled client must currently have a power level 2 or lower.
B. The client must be able to dynamically raise its power level to match the new AP power.
C. The AP must be RF visible to additional APs on the other side of the coverage hole for calibration.
D. The client must have WMM-PS disabled to allow for the increased power usage.
E. The AP serving the troubled client must currently have a power level higher than 2.

Answer: A, B

Question: 22

When implementing interface groups, how are the IP addresses sourced via DHCP for wireless clients?

A. through the primary interface of the group
B. through round robin between interfaces
C. through interface group definition
D. through the interface receiving the first response

Answer: B

Question: 23

New Updated 300-370 Exam Questions 300-370 PDF dumps 300-370 practice exam dumps: https://www.dumpsschool.com/300-370-exam-dumps.html

An engineer must open a support case with Cisco TAC. Which two commands verify the model and serial number of a controller? (Choose two)

A. show sysinfo
B. show udi
C. show inventory
D. show boot
E. show tech-support

Answer: AB

Question: 24

While reviewing Clean Air data in Cisco Prime Infrastructure, an engineer notices that a wideband jammer is not sending its Interferer Security Trap correctly. The engineer determines that the default seventy level has been changed. Which value does the engineer select to reset the seventy level to its factory setting?

A. informational
B. major
C. minor
D. warning
E. critical

Answer: D

Question: 25

An engineer is using various techniques to discover and isolate rogues on the network. For which technique must the engineer consider legal ramifications?

A. rogue AP containment
B. RF detection
C. switch port tracing
D. wire detection
E. Cisco Prime Infrastructure location services

Answer: A

Question: 26

Which Cisco WLC debug command allows you to determine if the certification process is failing in the CAPWAP messages?

A. debug pm pki enable
B. debug cert events enable
C. debug capwap events enable
D. debug capwap packet enable
E. debug capwap errors enable

Answer: E