Try These Juniper JN0-661 Exam Questions – Updated 2018

Free demo of Juniper Service Provider Routing and Switching JN0-661 certification exam is available before the real JN0-661 exam purchase once you are sure about the JN0-661 exam purchase then make the payment and get the Juniper Service Provider Routing and Switching JN0-661 exam dumps practice software instantly. PDF Questions and Answers booklet with the Juniper JN0-661 exam practice software is also available with an attractive offer of 30% discount. The booklet and practice test software together facilitates you for learning and practice both in the best manner. The most updated Juniper Service Provider Routing and Switching JN0-661 exam questions of Juniper JN0-661 exam are provided in the PDF booklet.

♥ VALID JN0-661 Exam Questions 2018 ♥

JN0-661 exam questions, JN0-661 PDF dumps; JN0-661 exam dumps:: https://www.dumpsschool.com/JN0-661-exam-dumps.html (133 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Juniper JN0-661 Dumps Exam Questions and Answers:

Version: 8.0
Question: 21

You are asked to deploy VPLS in your network as a new service for several customers, and you must identify the configuration and provisioning requirements for your customer. In this scenario, which two statements are correct? (Choose two.)

A. CE interfaces facing the service provider must be Ethernet interfaces.
B. VLAN IDs defined on CE interfaces must be the same on both ends unless otherwise negotiated
C. PE interfaces facing the core must have VPLS encapsulation enabled.
D. CE interfaces facing the service provider must be Layer 3 interfaces.

Answer: A, B

Question: 22

Click the Exhibit button.

ISP1 has created an L3VPN to connect CE1 and CE2 The PE-CE routing protocol is OSPF Referring to the exhibit, which technology will allow CE1 to receive Type 1 and Type 2 LSAs from CE2?

A. OSPF sham links
B. RIB groups
C. OSPF domain IDs
D. OSPF virtual links

Answer: D

Question: 23

Referring to the exhibit, you have configured an L3VPN that connects Site-1 and Site-2 together, but the BGP routes are being hidden on the PE routers. The topology in this scenario is shown below.
Site-1 > PE-1 > P-1 > P-2 > PE-2 > Site-2
Which two acttions would allow communication Site-1 and Site-2? (Choose two.)

A. Disable CSPF on under MPLS on P-1 and P-2.
B. Configure DGP on P-1 and P-2.
C. Enable RSVP for all interfaces on P-1 and P-2.
D. Enable LDP for all interfaces on all routers.

Answer: C, D

Question: 24

A layer 2 circuit (RFC 4447) is established between two PE routers to provide connectivity between two customer sites. Which two statements related to this deployment are true?

A. Kompella encapsulation is used in the data plane communications.
B. LDP must be used for the control plane communications
C. BGP must be used for the control plane communications.
D. Martini encapsulation is used in the data plane communications.

Answer: B, D

Question: 25

Referring to the exhibit, which router will be the RP?

A. R4 for all groups
B. R1 for group 224.1.1.11 and R4 for all other groups
C. R1 for all groups
D. R4 for group 224.1.1.12 and R1 for all other groups

Answer: A

Question: 26

You must ensure that r1’s IPv4 loopback address exists in r3’s inet 0 routing table
Referring to the exhibit, which statement is true?

A. An IPv4 unicast realm can be enabled on each router.
B. A policy can be configured on M to redistribute 172.16.100.1/32 into OSPFv2, which would cause r3 to eventually learn the route and place it into inet0.
C. A RIB group can be configured on r3 to copy that route into inet 0 because 172.16.100.1/32 exists in r3’s inet6.0 table
D. A policy can be configured on r1 to redistribute 172 16 100 1/32 into OSPFv3, which would cause r3 to eventually learn the route and place it into inet 0.

Answer: C

New Updated JN0-661 Exam Questions JN0-661 PDF dumps JN0-661 practice exam dumps: https://www.dumpsschool.com/JN0-661-exam-dumps.html